Drolet Escape 2100 Wood Stove

Drolet Escape 2100 Wood Stove

In stock
Drolet Escape 2100 Wood Stove
Does Not Ship To:
Calculate Estimated Shipping

This large wood stove on pedestal with ash pan is equipped with a heat exchanger in addition to offering a large glass area and a non-catalytic technology with low emissions; 1.32 g/h. Its efficiency and its reduced fuel consumption does not diminish in any way the power delivered by this new firebox. Hours of pleasure for true fans of wood heating!

Fuel type Dry cordwood
Recommended heating area-ft² () 1,000 - 2,700
Overall firebox volume 3.5
EPA loading volume-ft³ 2.84
Maximum burn time () 10 h
Maximum heat output (dry cordwood) (3) 110,000 BTU/h (32.2 kW)
Overall heat output rate < (3) (4) 18,200 BTU/h (5.3 kW) to 49,500 BTU/h (14.5 kW)
Average overall efficiency (EPA cribs/Douglas fir) (4) N.A. (HHV) (5) N.A. (LHV) (6)
Average overall efficiency (dry cordwood) (4) 71 % (HHV) (5) 76 % (LHV) (6)
Optimum efficiency (7) (8) 77 %
Average particulate emissions rate (1) 1.32 g/h
Average CO (9) 92 g/h

(1) This appliance is officially tested and certified by an independent agency.

(2) Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output.

(3) The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³. Other performances are based on a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.

(4) As measured per CSA B415.1-10 stack loss method.

(5) Higher Heating Value of the fuel.

(6) Lower Heating Value of the fuel.

(7) Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.

(8) Optimum overall efficiency at a specific burn rate (LHV).

(9) Carbon monoxyde.

General features

Combustion technology Non-catalytic
High-efficiency certified appliance Yes, EPA 2020 approved
Maximum log length 22"
Log positioning Over width
Chimney diameter 6"
Flue outlet diameter 6"
Type of chimney CAN/ULC S629, UL 103 HT (2100 °F)
Minimum chimney height (feet) 12'
Baffle type High quality vermiculite
Approved for an alcove installation Yes
Approved for a mobile home installation Yes, with fresh air intake
Door type Single, glass with cast iron frame
Glass type Ceramic glass
Glass surface – dimensions (Width X Height) 18 3/8" x 12 1/8"
Glass air-wash system Yes
Overall dimension (Height) 34 1/2''
Overall dimension (Width) 28 1/8''
Overall dimension (Depth) 31 7/8''
Door opening – dimension (Height) 9 7/8"
Door opening - dimension (Width) 19"
Firebox – dimension (Height) 12 7/8"
Firebox – dimension (Width) 22 7/8"
Firebox – dimension (Depth) 20 1/8"
Firebox lined with refractory bricks for better heat distribution Yes
Stainless-steel secondary-air system improving gas combustion Yes
Steel thickness – body 3/16"
Steel thickness – top 5/16"
USA standard (emissions) EPA
Canadian Standard (emissions) CSA B415.1-10
USA standard (safety) UL 1482, UL 737
Canadian standard (safety) ULC S627
Tested and listed as per applicable standards By an accredited laboratory (CAN/USA)
Warranty Limited lifetime
Minimum clearances to combustibles*
(Data expressed in inches. 1 inch = 25.4 mm)
  Canada United-States
  Single wall pipe Double wall pipe Single wall pipe Double wall pipe
Clearance – back wall 13 1/4" 6" 13" 6"
Clearance - corner 7 1/4" 7" 7 1/4" 7"
Clearance – side wall 14" 14" 14" 14"
Clearance – top (measured from the platform on which the appliance is installed)** 84" 84" 84" 84"

* The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner's manual, catalogues, flyers, magazines and/or web sites).

** Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.