JETCOAT Premium Rubberized Foundation & Roof Coating

In stock
SKU #
53760003
MFG #
64105
$52.99
JETCOAT Premium Rubberized Foundation & Roof Coating
$52.99
Does Not Ship To:
CA,HI,AK
Calculate Estimated Shipping
JETCOAT Premium Rubberized Foundation & Roof Coating

An elastomeric polymer modified asphalt emulsion designed for coating concrete foundations & roofs. Protects concrete foundations from moisture and water intrusion

• Liquid Rubber Membrane Seals & Water-proofs Concrete, Wood, Foamboard, Roofs & More
• Superior Resiliency and Flexibility - Over 300% Elongation
• ZERO VOC Advanced Water-Based Technology
• Bridges Small Cracks
• Environmentally Friendly Formulation
• Dries black

Uses -
• Most Roof Surfaces
• Coating
• Waterproofing
• Exterior Basement Walls (Concrete)
• Polystyrene/Styrofoam Insulation Board
• Poured Concrete Walls
• Foam
• Wood

Application -
Surface shall be clean, dry and free of any dirt or contaminants. Application temperature must be a minimum of 60º F and rising. Do not apply when temperature is expected to drop below 50º F within a 24- hour period. Be sure to wear eye protection and gloves when mixing and applying this product. In areas where dew or fog accumulates in the early evening, it is best to coat in the morning. Stop coating by early afternoon (3:00 pm) to prevent wash off, which will occur if dew, fog, or rain arrives before coating dries. Do not apply if rain is imminent or forecast within 24 hours of application. Stir container thoroughly. Apply using either a brush, trowel, or airless spray unit (suggested tip size .021 to .025). Apply material at a rate of 150 square feet per 4.75 gallon pail. Allow material to dry and cure for 24 hours prior to application of foam or drainage boards or backfilling. Clean tools with water immediately after use.

Coverage:
Approximately 31 square feet per gallon at 60 mils thickness